Inlet port layout and dimensions

[Phill]

Does anyone have, or know where I can find, a plan view of the engine showing the dimensions of the inlet port layout?

Ie. Distances between them so that I can make a mock up of the ITBs and get on with designing a throttle linkage.

[Phil911]

Have look on the jenvey website , they have some dimensions of the port centres and other measurements?   

[Phill]

Thanks for that Phil but I need the dimensions across the engine and the offsets between the banks. My fault, I should have been clearer. Useful to know though and their prices seem to have come down a bit?

[Phil911]

I can prob take some measurements on Tuesday as I'm putting an engine together , if that's any good , send me a pm and j can email dimensions and maybe pics ?

[Phill]

That's very helpful, thank you.

[MikeS911]

Hi Phil. Take a look at what I did, I have the measurement C/L to C/L between the ports as 486mm See the pics.

LAYOUT FOR THROTTLE BODIES

Throttle bodies fitted to flat board, Centre Line for Ports (2.7lt) are at 486mm and Cylinder 5 is mid way between Cyl1 and Cyl2.

 

My Injector Harness is wired as Bank 1 = Cylinders 1,6 and 2, Bank 2= Cylinders 4, 3 and 5, and per firing order.  I will be running as alternate squirts

(Note the fittings on top of the T-Bodies, I have six and these will attach  K&N Air filters) These are Triumph parts,

Here is what I did for my Throttle Linkage, I am using a 964 Throttle Cable from the Pedal Assy and have two cables from the wheel, one to each set of Throttle Bodies. The pivot unit I bought from Colin Belton but I would make something similar now, There are lots of ideas on DDK/Pelican, I can send other info if you want

Hope this helps 

MikeS