Jump to content

Distributor Cap and Rotor Arm


Recommended Posts

Ok so not much of a job but replaced the Cap and Rotor Arm yesterday as was an advisory on my last service when the garage cleaned up the contacts.  Never done before and simple enough but one of the spring loaded screws (the bottom one) was a pig to engage when trying to fasten the new cap.  Have SSIs and so had to remove some of the heating pipework to get access.  Seems to run a bit smoother now I think although was fine before if I'm honest.  Pics show it wasn't in great condition and needed doing.

IMG_1127.jpg

IMG_1129.jpg

Edited by double0
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...